Table of Contents
Advertisement
SPAZIO FORMA: Service & Maintenance manual - rev. 1.0
10.4.5. C
HECKING THE WEAR OF THE MOTOR ROLLER
1. With the rear and motor rollers, running track and tread-belt disassembled, check the state of
wear of the motor roller and clean it to remove any deposits. Replace if there are evident signs
of wear.
2. With the machine in motion, check the noisiness of the bearings. Replace in the event of
excessive noise.
10.4.6. C
HECKING THE WEAR OF THE REAR ROLLER
1. With the front and rear rollers, running track and tread-belt disassembled, check the state of
wear of the rear roller and clean it to remove any deposits. Replace if there are evident signs of
wear.
2. With the machine in motion, check the noisiness of the bearings. Replace in the event of
excessive noise.
10.4.7. C
HECKING THE SHOCK ABSORBERS
1. With the front and rear rollers, running track and tread-belt disassembled, check the condition of
the shock absorbers on either side of the running track. Replace if there are cracks or signs of
breakage.
10.4.8. C
HECKING THE TREAD
1. Turn off the machine by placing the switch in the 0 position (OFF).
2. Unplug the mains lead from the wall outlet.
3. Open the motor guard.
4. Check the state of wear of the tread motor drive-belt, turning it by hand using the motor
flywheel. Replace if it shows evident signs of wear.
5. Check the tension of the motor drive-belt. Adjust the tension if necessary.
10.4.9. C
HECKING THE SPEED CALIBRATION
1. Open the motor guard.
2. Check that, when the machine runs at a speed of 8.0 Km/h, the inverter displays a working
frequency of 39.8 Hz.
WARNING: this must be done with the machine opened and powered up.
10.4.10. C
HECKING THE OPERATION OF THE CARDIO RECEIVER
1. Using a separate heart rate monitor, put on the transmitter strap and check that the machine and
the separate monitor both measure the same heart rate, and that when the strap is disconnected
the machine does not receive any signal.
2. Using a heart rate frequency simulator, check that the machine detects the variations in the heart
rate.
-
BELT MOTOR DRIVE
-
BELT
Page 10.5
Advertisement
Table of Contents
