Mitsubishi Electric FR-A820-00046 Instruction Manual page 947

Parameters
Procedure for verifying parameters in USB memory
Copy the parameter settings of the verification source inverter to USB memory according to the procedure on page 5-743.
Move the USB memory to the inverter to be verified.
Turning ON the power of the inverter
The monitor display turns ON.
USB memory mode
Press
Displaying the file selection screen
Press
Selecting the file number
Turn
Parameter verification
Turn
"
Press
verification destination inverter is started. (It takes about 15 seconds to verify all the settings. During verification,
"
If there are different parameters, the different parameter number and "
To continue verification, press
"Verified file number" and "
Tab. 5-339: Verifying parameters in USB memory
NOTE
"
The set frequency may be incorrect. To continue verification, press the SET key.
FR-A800
to change to the USB memory mode.
three times to display "
to select the file number to be verified, and press
to display the setting "
" appears.
. Verification of the parameter settings copied to the USB memory and the parameter settings of the
" flickers.)
" flickers... Why?
Copying and verifying parameters using USB memory
Operation
" (file selection screen).
.
" (parameter copy verification mode) and press
.
" flicker after verification ends.
.
" flicker.
5 - 745