Hitachi X200-002SFE/NFU Instruction Manuals page 258

The following table lists the holding registers for the "B" Group Fine Tuning Functions.
Func.
Code
B001
B002
B003
B004
B005
B011
B012
B212
B013
B213
More user manuals on
Name R/W
Selection of automatic R/W Select inverter restart method,
restart mode
Allowable under- R/W The amount of time a power
voltage power failure
time
Retry wait time before R/W Time delay after under-voltage
motor restart
Instantaneous power R/W Two option codes:
failure / under-voltage
trip alarm enable
Number of restarts on R/W Two option codes:
power failure / under-
voltage trip events
Start freq to be used in R/W Three option codes:
case of freq pull-in
restart
Level of electronic R/W
thermal setting
Level of electronic R/W
thermal setting, 2nd
motor
Electronic thermal R/W
characteristic
Electronic thermal R/W
characteristic, 2nd
motor
ManualsBase.com
List of Holding Registers
Description
Four option codes:
00...Alarm output after trip, no
automatic restart
01...Restart at 0Hz
02...Resume operation after
frequency matching
03...Resume previous freq. after
freq. matching, then
decelerate to stop and
display trip info
input under-voltage can occur
without tripping the power
failure alarm. Range is 0.3 to 25
sec. If under-voltage exists
longer than this time, the
inverter trips, even if the restart
mode is selected.
condition goes away, before the
inverter runs motor again.
Range is 0.3 to 100 seconds.
00...Disable
01...Enable
00...Restart 16 times
01...Always restart
00...freq at previous shutoff
01...start from max. Hz
02...start from set frequency
Set a level between 20% and
100% for the rated inverter
current.
Select from three curves, option
codes: *1
00...Reduced torque 1
01...Constant torque
02... Reduced torque 2
B−31
Network Data
Reg. Range Res.
10A5h 0, 1, 2, 3 −
10A6h 3 to 250 0.1 sec
10A7h 3 to 1000 0.1 sec
10A8h 0, 1 −
10A9h 0, 1 −
1170 0, 1, 2 −
10ADh 2000 to 0.01 %
10000
1527h
10AEh 0, 1, 2 −
1528h