Hitachi X200-002SFE/NFU Instruction Manuals page 171

4−32
Safe Stop
The X200 inverter can perform the "uncontrolled stopping by removal of the motor
power" which is Stop Category 0, as defined in EN60204-1.
It is designed and approved suitable for the requirements of Safety Category 3 in
EN954-1, which is a protection against restart, called Safe Stop.
Prior to integration and use of X200 Safe Stop in an installation, a thorough risk
analysis on the installation must be carried out in order to determine whether the X200
Safe Stop functionality and safety category are appropriate and sufficient.
The Safe Stop function of X200 is activated by turning ON the hardware switch (S8)
located on the control card. When the switch S8 is made ON and if the emergency signal
(b-contact) is given to the terminal 3 of the logic terminal block, the inverter removes
the power to the motor only by integrated hardware, not software performance stands
in-between.
Total system comprises an inverter with AC motor and safety-tested external
disconnecting device. The external disconnecting device must have been approved for at
least safety category 3 according to EN954-1.
HIGH VOLTAGE: Dangerous voltage exists even after the Safe Stop is activated. It does
NOT
The X200 inverter complies to EN954-1
category 3. When you turn the switch S8 on
the control card, X200 shuts off the motor
power by hardware.
Emergency
signal
Reset
signal
When the switch S8 is made ON, input terminal for the emergency signal and the
terminal for the reset signal will be assigned automatically to terminal 3 and 4. At this
moment the parameter C003 is changed to EMR and parameter C004 is changed to RS
automatically, and cannot be changed manually. Following table shows the
assignments of each terminal according to the switch S8 condition.
More user manuals on
mean that the main power has been removed.
X200
EMR
Isolation
S8
Isolation
RS
ManualsBase.com
Latch
Motor
drive IGBT
Gate
shutoff
(Inverter)
circuit
Switch S8
(Right side)
Motor