Hitachi X200-002SFE/NFU Instruction Manuals page 128

3−54
Output Terminal Configuration
The inverter provides configuration for logic (discrete) and analog outputs, shown in the
table below.
Func.
Code
C021
C026
C028
The output logic conversion is programmable for terminal [11] and the alarm relay
terminal. The open-collector output terminal [11] defaults to normally open (active low),
but you can select normally closed (active high) for the terminal in order to invert the
sense of the logic. You can invert the logical sense of the alarm relay output as well.
Func.
Code
C031
C036
More user manuals on
"C" Function
Name /
SRW Display
Terminal [11] function 12 programmable functions available
for logic (discrete) outputs
(see next section)
OUT-TM 11 FA1
Alarm relay terminal 12 programmable functions available
function for logic (discrete) outputs
(see next section)
OUT-TM RY AL
AM signal selection Two available functions:
00...motor speed
01...motor current
(see after next section)
AM-KIND F
"C" Function
Name /
SRW Display
Terminal [11] active Select logic conversion, two option
state codes:
00...normally open [NO]
01...normally closed [NC]
O/C-11 NO
Alarm relay active state Select logic conversion, two option
codes:
00...normally open [NO]
01...normally closed [NC]
O/C-RY NC
ManualsBase.com
Run
Mode
Description
Edit
Run
Mode
Description
Edit
Defaults
-FE -FU
Units
(EU) (USA)
−
01 01
[FA1] [FA1]
05 05 −
[AL] [AL]
00 00
[freq] [freq]
Defaults
-FE -FU
Units
(EU) (USA)
00 00 −
01 01 −