Auto Average (1 To 10) - Konica Minolta CM-M6 Instruction Manual

Auto Average (1 to 10)

… „
Specify the number of measurements for auto averaging. Every time the measurement key/button is pressed, the
average of the data obtained from the specified number of continuous measurements is determined as sample
data.
"1 Times" is set as the number of measurements for automatic averaging under the initial settings.
Memo
Operating Procedure
1
Use [] or [] to move the cursor to "Auto
average", and then press the [Confirmation] key.
2
 and  will be displayed above and below the
count in the count selection. Use [] or [] to
specify a value.
Settings
01 to 10 Times:
{ „
Specify the number of measurements, from 1 to 10, to
perform when using auto averaging.
3
Press the [Confirmation] key.
The selection is confirmed and the screen returns to the
<Measurement setup> screen.
If [ESC] is pressed without pressing the [Confirmation]
Notes
key, the settings will not be changed and the screen will
return to the <Measurement setup> screen.
69
Start the procedure from the <Measurement cond.> - <Measurement setup> screen.
Sample
Measurement cond.
Measurement setup
Measurement angle
Auto average
1 Times
Manual average
1 Times
Manual average option
Manual save
Sample
Measurement cond.
Measurement setup
Auto average
Measurement angle
Auto average
0 3 / 1 0
Manual average
Manual average option
Manual save