Bosch MUC68 series Instruction Manual page 29

Problem
Display screen
E1~E6
Display screen
E0
Display screen
E1
Display screen
E2, E5, E6 or E7
Display screen
E3
Display screen
E4
Display screen
E8
Display screen
E12
If you are unable to solve the problem, always call the hotline!
You will find the telephone numbers at the back of these instructions.
Cause
Fault in the appliance.
Incorrect pan inserted or pan not
recognised.
The steam pressure function does
not work properly.
The appliance has overheated.
Short-circuit in the appliance.
Mains voltage too high.
Mains voltage too low.
Communication failure
When selecting a programme with
a high temperature (e.g. "soft fry"),
unsuitable ingredients have been
added (e.g. water). The programme
is aborted to prevent overpressure.
Troubleshooting
Remedy
Abort the preparation programme. Discon-
nect the appliance from the power supply.
Switch the appliance on again. If the
problem persists, contact customer service.
Insert the pan properly. If the display
persists for more than 20 seconds,
disconnect the appliance from the power
supply and contact customer service.
Disconnect the appliance from the
power supply and restart. If the problem
persists, contact customer service.
Disconnect the appliance from the power
supply and allow to cool down. Restart
the appliance once it has cooled down.
Disconnect the appliance from the power
supply and contact customer service.
Contact electricity provider or grid
operator. Have the power supply checked
by an expert.
Restart the appliance once it has cooled
down.
Remove the unsuitable ingredients
from the pan. Clean pan and then fill
correctly (e.g. with oil for the programme
"soft fry"). Leave the lid open depending
on the programme selected X "List of
preparation programmes" see page 24.
Restart preparation programme.
en
29