en
Preparation
Notes:
■ Certain preparation programmes or
steps are carried out with the lid open.
X See recipe book provided
■ If no input is made on the control
panel within 5 minutes, the appliance
automatically switches to standby mode.
1. Keep pressing button D until the
desired preparation programme is
selected.
The corresponding LED lights up in the
control panel and the pre-configured prepa-
ration time for the selected preparation
programme flashes.
2. Press button G to start the preparation
programme.
The appliance heats up the pan until the
target temperature is reached. During
the heating phase, lines that light up in a
clockwise direction appear in the display.
Once the target temperature is reached,
the lines go out and the preparation time is
shown in the display.
The preparation process starts automatically.
Note: When the programme [ pasta ] or
[ soft fry ] is selected, a repeating audible
signal is emitted and the display and
button G flash until the food has been
added and button G has been pressed.
12
The preparation time counts down.
Cooking produces steam, which escapes
from the appliance to prevent excess
pressure from building up.
Increasing or reducing the
temperature during preparation
If the current temperature has been set
too high or too low during preparation, this
can also be increased (by +10°C max.) or
decreased (by -10°C max.) accordingly
during the cooking process.
To increase the temperature, press and
hold button C. The current temperature will
be briefly shown on the display and will
then increase in 1°C increments until the
maximum value is reached (+10°C). Press
and hold the button until the temperature is
at the increased level desired.
To reduce the temperature, press and
hold button C. The current temperature will
be briefly shown on the display and will
initially increase in 1°C increments until the
maximum value is reached (+10°C). Once
the maximum value has been reached, the
display will jump back to the minimum value
(20°C lower). Press and hold the button
until the temperature is at the reduced level
desired.
To continue with the preparation programme,
press button G.
Note: If button G is not pressed, the
preparation programme will continue with
the temperature that was previously set.
When the preparation programme ends,
an audible signal sounds, and the indicator
[ finished ] and button G light up, or the
keep warm function is activated. X "Keep
warm function" see page 18