Bosch MUC68 series Instruction Manual page 15

There are 8 pre-configured preparation
programmes which can be used with
the steam pressure function. X "List of
preparation programmes" see page 24
W Risk of scalding!
■ Ingredients which are liable to froth up,
e.g. like milk and cream must not be
heated under steam pressure.
■ Do not use the steam pressure function
to soft fry food in oil under pressure.
1. Open the appliance. Open the pressure
locking handle for this purpose (M)
and press the opening button on the
basic appliance.
2. Fill the pan with the desired ingredients.
The measuring scale on the inside of the
pan can also be used to read the quantity.
Caution!
■ Never heat up the appliance under
steam pressure without having added
water or other liquids beforehand. Add
at least 250 ml of water.
■ Fill the pan with a maximum of 3.3 litres.
Only fill the pan at most half-full when
preparing food that expands during
cooking, e.g. rice or dried vegetables.
3. Close the appliance. Press the lid
down for this purpose until it clicks into
place and close the pressure locking
handle (N).
An audible signal sounds. The steam
pressure function is switched on.
4. Press button B to access function
selection mode.
The desired preparation programme is
selected in function selection mode and
all settings of the appliance are made.
Button B and the indicators [ my mode ]
and [ K ] are permanently lit. Button G
flashes. "00:00" is shown in the display.
Note: If no input is made on the control
panel within 5 minutes, the appliance
automatically switches to standby mode.
5. Keep pressing button D until the
desired preparation programme is
selected.
The corresponding LED lights up in the
control panel and the pre-configured
preparation time for the selected prepa-
ration p rogramme flashes. The indicator
"low steam pressure" [ K ] or "high steam
pressure" [ L ] lights up. Press button L to
switch between [ K ] and [ L ].
Note: If [ K ] or [ L ] does not light up, the
steam pressure function is not available for
the selected programme.
6. Press button G to start the preparation
programme.
The appliance heats up the pan until the
pre-configured steam pressure is reached.
During the heating phase, lines that light up
in a clockwise direction appear in the display.
Once the pre-configured steam pressure
is reached, the lines go out and the
preparation time is shown in the display.
Preparation en
15