Advanced Utilities; Display Mode Settings - BEAMEX MC5-IS User Manual

Advanced Utilities

Display Mode Settings

All the subsequent chapters:
• Display Mode Settings on page 77
• Transmitter/Switch Simulation on page 80
• Data Logging on page 83
describe the use of additional features that are available in MC5-
IS. Some of the utilities are firmware options and/or they require
some additional hardware before they can be utilized.
By default, MC5-IS displays all
measurement, generation and
simulation data in engineering
units. In Basic Mode you can also
select some special Display
Modes. To change the Display
Mode, select the Window setup
menu (Commands:
Window 2 Setup
B
/
Display Mode
3
choose /
All of the available special Display
Modes are described in the sub-
sequent chapters.
Note.
All special Display Modes are reset to
Mode if the quantity or port of the window(s) assigned to the spe-
cial Display Mode are changed.
Warning!
Be careful not to mistakenly read a value shown in special Dis-
play Mode as a value shown in Engineering Units. MC5-IS al-
ways displays the true measurement in the window's lower-
most row (Extra Info row) when a special Display Mode is ac-
tive.
Advanced Utilities
Menu
D
/ and
, if needed) and
.
26.04.2002 14:01
1
Pressure
Quantity
P2: INT20C/-1.0 ... 20.7 bar g
[Pressure]
gauge
1.0357
Function/Port
bar
[P2: INT20C]
Eng. Units
Display Mode
Scaling
[Eng. Units]
Percentage
Error
Unit
[bar]
2
Current
E: Current Measurement
HART
8.3524
mA
Pressure
Type
[gauge]
Zero
Pressure
Module
Window 1 Window 2
Others
Setup Setup
Engineering Units
Close
MENU
Display
77