Service; Firmware Update; Recalibrating Mc5-Is; The Battery Charger - BEAMEX MC5-IS User Manual

Service

Firmware Update

Recalibrating MC5-IS

The Battery Charger

MC5-IS may only be serviced by Beamex or a Beamex autho-
rized service. Contact:
BEAMEX OY AB
Ristisuonraitti 10
FIN-68600 Pietarsaari
FINLAND
E-mail: service@beamex.com
Opening of the casing of MC5-IS is not allowed due to ATEX safety
reasons.
There are, however a few things that anyone using MC5-IS may do.
The quickest way to see if a new firmware version is available is
checking out Beamex's web site (http://www.beamex.com). Go to
the web page dedicated to MC5-IS and see what it says about firm-
ware versions and downloads.
All you need is a Personal Computer and the Computer communi-
cation cable that connects MC5-IS to one of the serial ports in your
PC.
Remember to backup all the instrument data in MC5-IS, using e.g.
a calibration management software. Also check for possible release
notes accompanying the updated file.
Only laboratories approved by Beamex may recalibrate MC5-IS.
Contact Beamex or your local representative for information con-
cerning the recalibration of MC5-IS. Contact information is on the
first pages of this User Guide.
The charger is not intended to be serviced. When unusable it can
be thrown away according to local waste disposal regulations.
Service
29