Support for Table Top Use
The Wrist Strap and the Neck Support Strap
The support gives you a good viewing angle when MC5-IS is placed
on a table top. Lift the support at the back of MC5-IS and place
MC5-IS on the table top as shown in the picture.
MC5-IS has a wrist strap to enable ease of
use when MC5-IS is held in one hand.
The neck support strap helps you during field
calibration: Position MC5-IS in an angle that
allows reading the display when working. Al-
ternatively: Hang MC5-IS from, e.g. a valve
shaft so that the display is on the same level
as your eyes. Then your hands are free for
working with the connections etc.
MC5-IS Hardware
13