Mc5-Is' Modularity And Options; Hardware Modules/Options - BEAMEX MC5-IS User Manual

MC5-IS' Modularity and Options

Hardware Modules/Options

MC5-IS' Modularity and Options
MC5-IS includes several optional modules both in hardware and
firmware. This makes it possible to buy a calibrator with capabilities
according to current requirements. If additional needs arise later
on, add more modules to your MC5-IS and you will have a tool that
suits all demands.
MODULE
Base Unit (BU)
Internal Pressure
(1
Modules
(P1, P2 and P3)
External Pressure
Module connector
(PX1)
Electrical Module
(E)
Electrical and
Temperature
Module (ET)
Internal Reference
Junction Module
(RJ)
All MC5-IS' are built around the Base Unit (BU). All other modules
are optional, but at least one of the optional hardware modules has
to be available in order to measure/generate/simulate a signal.
1)
There are some limits on the total amount of certain modules/
connectors. See chapter The Upper Panel on page 5 for addi-
tional information concerning this matter.
2)
E module's HART communication requires that the respective
firmware option is installed.
DESCRIPTION
Required module. Includes the case,
display, keyboard, battery pack, common
electronics as well as a connector for an
external pressure module (PX1) and the
serial communication connector (RS232).
Modules with positive and compound gauge
pressure measurement capability and a
barometric module enabling also absolute
pressure measurement together with other
modules.
Connection for external modules capable of
(1
measuring high pressures up to 1000 bar
(approx. 14500 psi).
Voltage, low voltage, current and frequency
measurement. Also pulse counting, switch
testing, HART communication
sink.
Resistance, RTD and thermocouple
measurement/simulation. Low voltage
measurement/generation. Voltage,
frequency and pulse generation. Current
sink
Internal reference junction compensation for
thermocouple measurement/simulation.
Cannot be used without the ET Module.
(2
and current
23