Changing The Value Of The Generated/Simulated Signal - BEAMEX MC5-IS User Manual

Changing the Value of the Generated/Simulated Signal

Fine Tuning the Generated/Simulated Signal
Warnings!
When selecting a generation/simulation function, MC5-IS al-
ways starts with zero output (not when simulating a resistance).
This is done to prevent damages in the connected instrument.
Be careful when increasing the generated/simulated signal. If
an instrument that cannot withstand the generated signal is
connected to MC5-IS, the instrument may get seriously dam-
aged.
Move the field indicator on the display until it surrounds the value of
generated/simulated signal (use the
cursor keys).
Enter the new value using the numeric keys. You may cancel the
editing by pressing the
Function Key removes the rightmost digit.
Accept the new value by pressing either the
Function Key.
Note.
The dual function of the keys:
generation field. The keys only represent numbers.
Press either of the left or right arrow
keys ( or ) to start the Fine Tun-
ing of the selected numeric field.
Then one of the digits in the num-
ber in underlined indicating which digit can be fine tuned. If needed,
press the left or right arrow buttons again to select another digit for
Fine Tuning.
To change the value of the undelined digit, use the up and down
arrow keys ( ). The changes take effect immediately.
To end Fine Tuning, press either the
number using the numeric keys) or the
Notes.
You cannot exceed the minimum/maximum limit of the quantity with
the Fine Tuning utility.
The fine tuned value follows the resolution properties of the gener-
ated/simulated quantity.
Generating/Simulating
Field
/
B
Cancel
/ Function Key. The
A
, and
Edit
/
C
D
Function Key or the
Delete
/
C
key or the
is not available in a
Function Key (to enter a
Close
/ Function Key.
OK
/
D
57