Pulse Generation - BEAMEX MC5-IS User Manual

Pulse Generation

The pulse generation terminals are located in the
to square wave frequency output, but it generates a predefined count of all positive or
symmetric pulses.
Required settings
Quantity
Funct/Port
Polarity
Also check the
Enter the amount of pulses MC5-IS should
generate in the pulse generation window.
Also enter the amplitude and frequency
to be used.
The pulse generation starts immediately
after the amount of pulses value is entered.
Next...
Options/description
Pulses
ET: Pls(gen)
setting.
Note.
If you change the frequency after the pulse generation has started,
the frequency is adjusted during the current cycle, but the frequency
is not correct until the next cycle.
Frequency Generation on page 62
Pulse Counting on page 47
Special Generations on page 67.
Generating/Simulating
module. Pulse generation is similar
ET
T / C I N T . R J
T / C , L o w V
T / C
W I R E S
O N L Y
S E N S O R M E A S U R E
H A R T 1
4 w m e a s ®
1 1     m e a s / s i n k
R , R T D V , V ,         , ,
s i n k s i n k
V , , C o m
m e a s / s i m 3 w m e a s
U o : 1 6 V
I o : 2 4 m A
P o : 1 4 5 m W
& S I M U L A T E O U T P U T M E A S U R E
E T E
L o w V
63