About The Charger And The Charging Procedure - BEAMEX MC5-IS User Manual

MC5-IS Hardware

About the Charger and the Charging Procedure

The charger is connected to the charger connector at the bottom of
MC5-IS. The charging electronics informs you of the phases of the
charging procedure with the help of the charge status light.
When connecting the charger, the charging electronics first checks
the starting conditions. At this stage the charge status light is green.
If the starting conditions are not met (e.g. the temperature is out-
side the allowed range), the status light is blinking green.
When the charge status light is blinking red, a recharging is in
progress. MC5-IS may be used during the recharging phase. Empty
batteries are fully charged in approx. 5 hours.
When the charge status light is green, the batteries are charged. At
this stage the charging electronics provide a support voltage that
prevents the batteries from discharging
Warnings!
USE ONLY THE CHARGER PROVIDED WITH THE CALIBRATOR
(BC14-IS). USE THE CHARGER IN SAFE AREA ONLY!
The charger accepts input voltages from 100 to 240 VAC.
The charger should only be used indoors in a non-hazardous
area and the temperature should be in range 10 ... 35 °C
(50 ... 95 °F).
11