Rau Led Indicators; Table 5-4 Remote Access Unit Led States - ADC InterReach Fusion Installation, Operation And Reference Manual

RAU LED Indicators

5.3
5-6
CONFIDENTIAL
NOTE: For system performance, it is important that you use only low loss,
solid copper center conductor CATV cable with quality F connectors that use
captive centerpin conductors. Refer to Appendix A for specific information.
RAU LED Indicators
Upon power up, the RAU goes through a two-second test to check the LED lamps.
During this time, the LEDs blink green/green red/red, letting you visually verify that
the LED lamps and the firmware are functioning properly.
NOTE: Refer to Section 9 for troubleshooting using the LEDs.
Status LEDs
The RAU status LEDs can be in one of the states shown in Table 5-4. These LEDs
can be:
off
steady green
steady red
There is no off state when the unit's power is on.
Remote Access Unit LED States
Table 5-4
LED State
Off
LINK
ALARM Off
Green
LINK
ALARM Green
Green
LINK
ALARM Red
Red
LINK
ALARM Red
Green (60-ppm)
LINK
ALARM Green (60-ppm)
InterReach Fusion Installation, Operation, and Reference Manual
Indicates
• The RAU is not receiving DC power.
• The RAU is powered and is not indicating a fault
condition. Communication with the Fusion Hub
is normal; however, the system test may need to
be performed or a warning condition may exist
(use AdminBrowser to determine this).
• The RAU is indicating a fault or lockout condi-
tion, but communication with the Fusion Hub is
normal.
• The RAU is reporting a fault and is not able to
communicate with the Fusion Hub
• The RAU is reporting a lockout condition, but
communication with the Fusion Hub is normal.
D-620610-0-20 Rev D