Key
Displayed
position
Middle
[F3]
right
3
[F4] Right end
3. 1. 2
This inverter has four types of display modes.
The display modes can be switched in the following two ways.
9
• Press the [ESC] key.
• Press any of the [F1] - [F4] keys to which the applicable display mode is assigned.
(1)
[Standard mode]
• This is the mode that is displayed first power on.
• The operation status (output frequency of the inverter, etc) is always displayed and alarms
• Setting of the panel operation frequency, EASY key function operation, language selection,
(2)
[Setting mode]
• Parameters are set in this mode.
• All the parameters are displayed.
• [Easy mode] is also available in which only the registered parameters are displayed.
(3)
[Easy mode]
• Parameters are set in this mode.
• In this mode, only the registered parameters are displayed.
3. [Basic operation] Operation panel and screen display
Screen display
Display
Inverts the backlight color (white or red)
Move setting to right
Page down (If there are more than six choices)
R (Back)
Searches backward
Setting
Displays the screen for [Setting mode]
Return
Same as [ESC] key (Return to the screen of [Monitor mode])
X10
Sets the number third from the left
Jog
The inverter performs jog run while the key is pressed
Move setting to right
Move setting to left
Monitor
Displays the secreen for [Monitor mode]
F2-- to F1--
Displays parameters of next hundreds (F200s to F100s)
C1-- to C0--
Displays parameters of next hundreds (C100s to C000s)
Displays details monitor
F (Next)
Searches forward
X1
Sets the far right number
Display mode
and trips when they occur.
In the default setting, the output frequency is displayed. The display contents can be
selected with <F710: Standard mode display>.
and screen setting are also made in [Standard mode].
Function
3-6
E6582062
Reference
[3. 1. 3]
[3. 1. 3]
[4. 2. 1]
-
[4. 2. 1]
[3. 1. 2]
-
[4. 2. 3]
[6. 10]
[3. 1. 4]
[3. 1. 4]
[3. 1. 2]
[4. 2. 1]
[4. 2. 1]
[8. 1. 1]
[4. 2. 1]
[4. 2. 3]