Toshiba TOSVERT VF-AS3 Instruction Manual page 594

Trip
display
EEP1
EEP2
EEP3
4
EF2
4
EPHI
EPHO
Err2
8
Err3
9
Err4
Err5
Err6
Err7
13
Err8
Err9
13. Trip information and measures
Failure
Trip name
code
0012 EEPROM Fault occurred during internal data writing. Turn off the power and then turn it on
fault 1
0013 EEPROM 1) While setting <tyP: Default setting>, the
fault 2 power was turned OFF or momentary
power failure occurred.
2) Fault occurred during internal data
writing.
0014 EEPROM Fault occurred during internal data
fault 3 reading.
0022 Grounding 1) Grounding fault occurred in the output
fault * wiring or the motor.
2) Fault can occur depends on motor, in
case of rapid acceleration/deceleration.
0008 Input phase 1) Input side phase has failed.
loss *
0009 Output phase 1) Output side phase has failed.
loss * 2) Output current is quite small (less than
8%) to motor rated current.
0015 RAM fault Control RAM fault.
0016 ROM fault Control ROM fault.
0017 CPU1 fault A Control CPU fault.
0018
Communication RS485 communication timed out.
time-out
(RS485)
0019 Gate array Fault in the gate array.
fault
001A Current Fault in the output current detector.
detector fault
001B Communication Communication option timed out.
time-out
(option)
001C Panel While running with a run command from
disconnection the operation panel and extension panel,
during run the cable connecting the inverter and
panel are disconnected.
*Enable/Disable can be selected for trip with a parameter.
Detection factor
again.
If the fault occurs again, contact your
Toshiba distributor.
1) Set <tyP> again.
2) Turn off the power and then turn it on
Turn off the power and then turn it on
again.
If the fault occurs again, contact your
Toshiba distributor.
1) Check grounding fault in the wiring on
2) Increase the acceleration/deceleration
1) Check phase failure in the wiring on the
1) Check phase failure in the wiring on the
2) Set <F605> to 0
Fault in internal inverter.
Contact your Toshiba distributor.
Fault in internal inverter.
Contact your Toshiba distributor.
Fault in internal inverter.
Contact your Toshiba distributor.
Check the communication equipment and
wiring on RS485 communication.
Fault in internal inverter.
Contact your Toshiba distributor.
Fault in internal inverter.
Contact your Toshiba distributor.
Check the communication equipment and
wiring on communication option.
Check the connection on the inverter and
panel.
13-4
E6582062
Measures
If the fault occurs again, contact your
Toshiba distributor.
again.
If the fault occurs again, contact your
Toshiba distributor.
the output side and the motor.
time. <ACC/dEC acceleration/
deceleration time 1>
input side.
output side.