Toshiba TOSVERT VF-AS3 Instruction Manual page 601

Message
English
display
CHn Setting for China
CLr Reset command
acceptable
db During DC braking
dbOn During motor shaft
fixing
E1 Panel display one
digit overflow
E2 Panel display two
digits overflow
E3 Panel display three
digits overflow
EASy Easy mode
End Last of data
EOFF Emergency off
command
acceptable
Err1 Frequency point
setting error
EU Setting for Europe
FAIL Password failure
FIrE During Fire speed
run/Forced run
FJOG Fwd JOG
HEAd Head of data
HI Upper limit of
setting value
Init During Initializing
JP Setting for Japan
LO Lower limit of
setting value
LStP During run sleep
n--- No detailed
information of past
trip
Description
Setting for China is selected in the setup
menu.
The following was operated after trip is
occurring.
1) Pressed [STOP] key once.
2) Set the reset terminal ON.
(During trip resetting operation)
DC braking in progress.
Motor shaft fixing in progress.
The display digit on the operation panel
overflowed by one digit.
The display digit on the operation panel
overflowed by two digits.
The display digit on the operation panel
overflowed by three digits.
Switched to [Easy mode].
The last data item in <History function>.
When a run command is other than the
operation panel, [STOP/RESET] key was
pressed once.
The setting on point 1 and point 2 of the
frequency command is close.
Setting for Europe is selected in the setup
menu.
Entered number in <F739: Password
verification> does not match <F738:
Password setting>.
Fire speed run/Forced run is in progress.
("FIrE" and the output frequency are
alternately displayed)
Forward jog run in progress.
The first data item in <History function>.
The upper limit of the setting value.
• Set <tyP: Default setting> = "3" or "13" and
initialization is in progress.
• Region setting in progress with the setup
menu.
Setting for Japan is selected in the setup
menu.
The lower limit of the setting value.
Run sleep in progress.
While "nErr" and a value are alternately
displayed, [OK] key is pressed and detailed
information are read.
13-11
E6582062
Remarks
-
Reset is performed with the following
operation.
1) Press [STOP] key again.
2) Set the reset terminal OFF.
-
A message indicates the motor fixing control
in progress. When standby is turned OFF, the
control stops.
-
-
-
-
-
To apply emergency off, press [STOP] key
again.
If emergency off does not occur, press other
keys.
Set apart point 1 and point 2 of the frequency
command.
-
-
A message indicates fire speed run/forced
run in progress. It stops when turning the
power OFF.
-
-
-
No problem if the display shows "0.0" after
several seconds.
-
-
-
Normal display.
13. Trip information and measures
I
II
III
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18