Toshiba TOSVERT VF-AS3 Instruction Manual page 417

6. 34. 9 Selecting panel stop pattern
<F721: Panel stop>
■ Function
This parameter is used to select a panel stop pattern by pressing the [STOP] key on the operation
panel from Deceleration stop or Coast stop.
■ Parameter setting
Title Parameter name
F721 Panel stop
■ Selecting a setting value
0: Deceleration stop
The motor decelerate to a stop in the deceleration time set with <dEC: Deceleration time 1>.
1: Coast stop
The inverter cuts off power supply to the motor. The motor comes to a stop after coasting for a while.
Depending on the load, the motor may keep running for a longer time.
• How to operate the operation panel -> Refer to [3. 1. 1].
• How to switch display mode on the operation panel -> Refer to [3. 1. 2].
Reference
• Procedure to change parameter setting -> Refer to [4. 2. 3]
• <dEC: Deceleration time 1> -> Refer to [5. 2. 4]
F721 : Panel stop
0: Deceleration stop
1: Coast stop
Adjustment range
0: Deceleration stop
1: Coast stop
6-175
E6582062
STOP 0.0Hz
14:14
Default setting
0
6. [Advanced] How to use parameters
3
4
6
9