Checking That Tcp Acceleration Is Operational; Checking That Web Acceleration Is Operational - Hughes HX200 Installation Manual

Checking that TCP
Acceleration is operational
Checking that Web
Acceleration is operational
If the Tx Code reads
the satellite router is transmitting signals properly. Proceed to

Checking that TCP Acceleration is operational.

If any other Tx Code appears, the satellite router is not
transmitting signals properly. Click on the Tx Code and
follow the troubleshooting procedures that appear on the
screen.
Transmission Control Protocol (TCP) Acceleration is a
proprietary protocol provided by the HX system. It optimizes
performance for TCP/IP-based applications, including faster
downloads over satellite.
1. Navigate to the System Control Center System Status page.
2. Check the message in the
If the message reads
enabled. Proceed to Checking that Web Acceleration is
operational.
If the message says
disabled. Perform the following steps:
a. Check the receive and transmit signals as explained above.
to ensure that the satellite router is transmitting and
receiving properly. If it is not, troubleshoot as previously
described.
b. If the satellite router is receiving and transmitting properly
but TCP Acceleration is still not operational, power cycle
the HX200 by turning it off using the power switch on the
rear panel, waiting 10 seconds, then turning it back on.
c. Check the
TCP Acceleration Status
enabled, but you still cannot access enterprise network
resources, proceed to Checking that Web Acceleration is
operational. If TCP Acceleration is still disabled, contact
Technical Support.
Web Acceleration is a system feature that enhances the browsing
experience on non-secure web sites. Follow these steps to
confirm that Web Acceleration is operating properly:
1. From the System Control Center Home page or any of it's
sub-pages, check the System Status indicator. If the indicator
is yellow, Web Acceleration may not be operational.
Continue with Step 2.
2. Access the System Status page by clicking the System Status
indicator and check the message in the
field. If the message says
Status
Acceleration is enabled. Proceed to Checking system gateway
connectivity.
1038054-0001 Revision A.04 - Inspection Draft
Transmitter ready (TxCode 8)
TCP Acceleration Status
, TCP Acceleration is
Operational
, TCP Acceleration is
Inactive
field again. If it is
Web Acceleration
Operational
Chapter 6 • Troubleshooting
,
field.
, Web
81