Commissioning The Hx200; Antenna Location Screen - Hughes HX200 Installation Manual

Commissioning the HX200

TO BE REPLACED
Follow these steps to commission the satellite router:
1. From the Broadband Satellite Setup screen, click
Registration -
appears as shown in Figure 13.
Figure 13: Antenna Location screen
2. Enter the ZIP code of the location in which you are installing
the satellite router and click Next. If installing the HX200
outside the United States, you can enter the location manually
by completing steps a and b below.
a. Select the
Enter Location Manually
Next. The Manual Entry of Antenna Location screen
appears as shown in Figure 14.
b. Enter the correct latitude and longitude for the location and
click Next.
Chapter 3 • Commissioning the HX200 satellite router
1038054-0001 Revision A.04 - Inspection Draft
Installer. The Antenna Location screen
check box and click
27