Completing The Installation; Confirming That All Files Are Current - Hughes HX200 Installation Manual

Confirming that all files
are current

Completing the installation

This chapter discusses tasks that must be completed after the
HX200 satellite router has been installed and commissioned.
The following topics are discussed:
• Confirming that all files are current on page 37
• Connecting the HX200 satellite router to a computer on
page 38
• Printing the System Information page on page 39
• Creating a shortcut to the System Control Center on page 40
Follow these steps to confirm that the HX200 satellite router is
operating with the most current software version:
1. Access the HX200 System Control Center and click the
System Status indicator. For more information, see Chapter 5
– The System Control Center.
2. At the System Status page, check the
line message. If it reads
Status
up-to-date
Note: It may take up to 15 minutes after completing the
commissioning process for all files to be downloaded to the
satellite router from the system gateway, and therefore, for the
All files are up-to-date
message does not appear after 15 minutes, power cycle the
unit by turning it off using the power switch on the rear panel,
waiting 10 seconds, and then turning it back on. If the
message still does not appear, contact Technical Support.
1038054-0001 Revision A.04 - Inspection Draft
All files are
, the unit has been successfully commissioned.
message to appear. If the
Chapter 4 • Completing the installation
Chapter 4
Software Download
37