Noc Override; Antenna Pointing - Hughes HX200 Installation Manual

Antenna pointing

Chapter 3 • Commissioning the HX200 satellite router
20
1038054-0001 Revision A.04 - Inspection Draft

NOC override

In some cases the NOC may need to override the allowed inroute
symbol rates mask due to the installer's selection. In order to
override the selection from the NOC, the following parameter
must be set in the satellite router's InrouteProfile:
shinrtCfLocalInrtMaskOverride=2
As a result of the NOC override, the satellite router uses the
inroute rates specified by the NOC instead of the transmit radio
selection.
Follow these steps to use the Antenna Pointing feature on the
HX200 web-based interface to peak the receive and transmit
signals:
1. Turn off the HX200 using the power switch on the rear panel.
2. Connect the receive and transmit coaxial cables to the
HX200.
3. Place the OPI in the receive cable line, if applicable.
4. Apply power to the HX200.
5. Open a web browser on the installer laptop and navigate to
the Broadband Satellite Setup screen as explained in Entering
manual commissioning parameters on page 15.