Modifying And Deleting Firewall Rules; Modify/Delete Firewall Rule - Hughes HX200 Installation Manual

Field name
Protocol Type
Rule Action
Source Port
Numbers
Destination Port
Numbers
Modifying and deleting firewall
Chapter 5 • The System Control Center
64
1038054-0001 Revision A.04 - Inspection Draft
Table 8: Firewall rule configuration fields (Continued)
Value
TCP This is the Protocol that is encapsulated in the IP packet. A value of
UDP OTHER indicates the value in the If "Other", specify Protocol
ICMP Number field should be used.
ANY
OTHER
PERMIT A rule which has NOACTION is the default catch-all rule and it
BLOCK should be the last rule in the table
NOACTION
One or more Up to 5 port numbers separated by commas. If the Protocol Type is
comma-separated TCP or UDP, you must enter at least one port number in this field
Integer values. or the Destination Port Number field.
One or more Up to 5 port numbers separated by commas may be entered. Only
comma-separated enter port numbers if Protocol Type is TCP or UDP.
Integer values.
You can modify or delete firewall rules at the Firewall
rules
Configuration page. To modify or delete a firewall rule:
1. Click the
firewall rule.
The Firewall Rule Configuration page appears, as shown in
Figure 38, with the rule values displayed in the fields. Note
that Figure 38 shows the page with the
menu displayed.
Figure 38: Modify/delete firewall rule page
2. To modify a rule, change the values in one or more of the
fields, then click Save Rule.
3. To delete a rule, click Delete Rule.
Description
Modify/Delete link in the leftmost column of a
pull-down
Rule Action