Updating The Fallback.bin File - Hughes HX200 Installation Manual

Updating the
fallback.bin file
8. Click OK.
9. Restart the computer even if Windows does not require you
to do so. This ensures that the network settings are
automatically reset.
Follow the steps below to update the
this process, the files containing the current software release are
transferred to the satellite router, overwriting the older files.
1. Confirm that the installer laptop Ethernet cable is connected
to the HX200 satellite router by performing a ping test:
a. Open a DOS command line prompt or Command window
on the installer laptop.
b. Type
ping 192.168.0.1
c. Press E .
NTER
Continue with step 2 if the ping test is successful. Refer to
Troubleshooting the update on page 110 if the ping test fails.
2. Navigate to the location on the laptop where you saved the
Fallback Updater utility and its supporting files in Step 4 of
Saving the utility on the installer laptop on page 101.
3. Launch the Fallback Updater utility by opening the
HX_Updater.exe
4. Type
192.168.0.1
Updater window as shown in Figure 66. This value is the
HX200 IP address.
Figure 66: Entering the satellite router IP address
5. Click OK.
During the update process, status messages will appear in the
message window between the address field and the OK button.
When the update is complete, the utility automatically closes and
the HX200 reboots.
Refer to Troubleshooting the update if the utility does not
automatically close or the HX200 fails to reboot.
Appendix C • Updating the satellite router software
1038054-0001 Revision A.04 - Inspection Draft
fallback.bin
.
file.
in the IP address field on the System
file. During
109