Hughes HX200 Installation Manual page 73

–
Receive Polarization –
horizontal or vertical.
–
Router Address –
gateway router used to route data sent by the satellite
router.
• Software Configuration section
translation (NAT), DHCP, and firewall features are enabled
or disabled at the system gateway per site requirements and
cannot be changed by remote users.
–
Network Address Translation
allow multiple computers to share a single address on the
Internet, also allows pre-configured remote networks to be
integrated easily with the system network.
–
Dynamic Host Configuration Protocol
enabled, simplifies network configuration of the
computers. The computers need only to be set up to
"Obtain IP address automatically."
– This feature is not available with the HX
Turbo Page –
system.
– If enabled, implements firewall rules and related
Firewall –
policies. Firewall rules are configured on the system
gateway in satellite router profiles.
• Transmit Radio Info
–
Transmit Radio Wattage –
the transmit radio part number, depending on which was
selected during the commissioning process. See Chapter 3
– Commissioning the HX200 satellite router for details.
Chapter 5 • The System Control Center
1038054-0001 Revision A.04 - Inspection Draft
Polarization orientation; either
IP address of the primary system
Network address
–
(NAT) Typically used to
–
(DHCP)
May list either the wattage or
If
–
59