Configuring The Tcp/Ip Properties On The Installer Laptop; Windows Xp - Hughes HX200 Installation Manual

Configuring the TCP/IP
properties on the
installer laptop
Appendix C • Updating the satellite router software
102
1038054-0001 Revision A.04 - Inspection Draft
3. Open the self-extracting file. The Self-Extractor window
appears as shown in Figure 56.
4. Use the Browse button to select a location in which to unzip
and save the utility and its supporting files.
Note: Make a note of the location in which the utility and its
supporting files are saved. You will need to know the location
of these files to use the utility.
5. Click Unzip.
Before using the Fallback Updater utility, you must first
manually configure the TCP/IP properties on the installer laptop.
This section explains how to configure TCP/IP properties for
Windows 98 Second Edition (SE), Windows Millennium Edition
(Me), Windows 2000, and Windows XP operating systems.

Windows XP

1. From the Windows desktop on the installer laptop, select
Start→ Settings→ Control Panel
and Dial-up Connections
Note: If the Control Panel is in Category view, select
Network and Internet Connections, then select Network
Connections.
2. A list of network adapters appears as shown in Figure 57.
The
or High-Speed Internet heading. If it does not, the network is
not installed correctly.
Figure 56: Saving the Fallback Updater utility
icon.
Local Area Connection
. Double-click the
icon must appear under the LAN
Network