Hughes HX200 Installation Manual page 90

LED Appearance
Power Solid
Flashing
Off
System On
Off
LAN On
Blinking
Chapter 6 • Troubleshooting
76
1038054-0001 Revision A.04 - Inspection Draft
Table 9: Satellite router front panel LED operation (Continued)
Power is on and the satellite router is functioning normally
The satellite router is operating with the fallback.bin (backup) version of
software.
This usually happens when the satellite router is first installed. The satellite
router operates with fallback.bin until the primary version of software,
main.bin, successfully downloads over the satellite link
No power.
If the Power LED is off, take the following steps. Note that if the Power LED is
off, it is likely that the remaining LEDs will be off as well.
1. Check all cable connections and tighten any that seem loose.
(See the Caution statement that follows Figure 3 on page 11.)
2. If the problem persists, contact Technical Support.
Fatal Error Indication:
If after power-up or a reset the Power LED is off and one or more of the other
LEDs is flashing, the unit could have a fatal error and may have to be
replaced. If you do not see these LED indications, proceed to the next
troubleshooting step.
If there is a fatal error indication (Power LED off and other LED or LEDs
flashing), try power cycling the satellite router by disconnecting the power cord
from the power strip or surge protector, waiting 10 sec, and then plugging it
back in. The satellite router may recover. If the fatal error indication continues,
the satellite router must be replaced. Contact Customer Support.
The satellite router has established a connection with the NOC.
Condition preventing full operation.
If the System LED does not light up, but the Transmit and Receive LEDs are
functioning normally, there may be a problem at the system gateway. Perform
the following steps:
1. Wait 15 minutes. If there is a problem at the gateway, it may soon be
corrected and the System LED light up. You can then resume normal
operation.
2. If the LED does not come on after 15 minutes, power cycle the satellite
router by turning it off using the power switch on the rear panel, waiting 10
seconds, and then turning it back on.
3. If the problem persists, contact Technical Support.
LAN is connected and usable.
There is transmit or receive activity on the LAN.
Description
.