Create Firewall Rule - Hughes HX200 Installation Manual

Field name
Rule ID Integer
Rule Action PERMIT
BLOCK
NOACTION
Source IP Address IP address
Default: 0.0.0.0
Source Subnet Mask IP address
Destination IP IP address
Address Default: 0.0.0.0
Destination Subnet IP address
Mask
The Firewall Rule Configuration page shown in Figure 37
appears. Note Figure 37 shows the page with the
pull-down menu displayed.
Type
3. Enter values in the Firewall Rule Configuration page as
indicated in the field definitions in Table 8.
Note: To clear the fields in the rule configuration page and
start over, click Restore.
4. Click Save Rule. The rule is saved.
Repeat Step 2 through Step 4 to add additional rules.
Figure 37: Create firewall rule page
Table 8: Firewall rule configuration fields
Value
The rule ID is automatically generated and cannot be edited.
The action to perform on packets that match the rule IP
address/port criteria. BLOCK drops the packet. PERMIT passes
the packet. A rule which has NOACTION is the default catch-all
rule and it should be the last rule in the table.
This is the source IP address for the packets received at the
satellite router. This is used in conjunction with Source Subnet Mask
to define the set of matching source IP addresses.
This is the IP address mask associated with Source IP Address. An
address mask of 0.0.0.0 is considered as a don't care value, where
any IP address matches the configured IP address. Set bits in the
mask do not have to be contiguous.
This is the destination IP address for the packets received at the
satellite router. This is used in conjunction with Destination Subnet
Mask to define the set of matching destination IP addresses.
This is the IP address mask associated with Destination IP
Address. An address mask of 0.0.0.0 is considered as a don't care
value, where any IP address will match the configured IP address.
Set bits in the mask do not have to be contiguous.
Description
Chapter 5 • The System Control Center
1038054-0001 Revision A.04 - Inspection Draft
Protocol
63