Hughes HX200 Installation Manual page 64

Code
1 The receiver is in pointing mode
2 The receiver is in factory or gateway mode
3 The receiver is not locked to a signal
4 The receiver is locked to the wrong network
Chapter 5 • The System Control Center
50
1038054-0001 Revision A.04 - Inspection Draft
Table 6: Receive code (RxCode) messages and corrective actions
Message Corrective actions
Indicates that the installer is performing antenna
pointing. In this mode, the transmitter is disabled
because the installer is working near the antenna. If
this occurs during normal operation, power-cycle the
satellite router by turning the unit off, waiting 15
seconds, and turning it back on.
Used for satellite router testing purposes only and
should never appear during normal operation. If it
appears during normal operation, power-cycle the
satellite router by turning the unit off, waiting 15
seconds, and turning it back on.
If the satellite router was operating before, this
condition is probably caused by inclement weather
conditions and may resolve itself when the weather
improves. Could also indicate that the satellite router
cannot receive the signal from the system gateway.
This message indicates a signal level lower than 30,
which could result from a weather outage at the user
location, a system gateway outage, a misaligned or
faulty antenna, or faulty cabling. If this message
continues to appear under normal weather
conditions, power-cycle the satellite router by turning
the unit off, waiting 15 seconds, and turning it back
on.
Should only occur during installation. Otherwise it
indicates that the receiver is locked to an incorrect
system satellite. Can also appear if the installer
entered incorrect information during manual
pointing. If this condition occurs during normal
operation, it could indicate a manual change to the
satellite parameters, or that the antenna has
become misaligned. Ensure that the antenna is
aimed at the correct satellite and verify that the
correct satellite parameters were entered during
registration.