If any other RxCode appears, the router is not receiving signals properly. Click the
RxCode, and follow the troubleshooting procedure that appears. Click the
RxCode for explanation of the problem and/or troubleshooting information.
Note: The RxCode shown is an example.
Confirming the transmit signal
To confirm that the router is properly transmitting signals to the satellite:
1. At the System Control Center, click the
The Transmission Information page appears.
2. In the Transmit Status field, check the TxCode.
If the TxCode is Transmitter Ready (RxCode 8) the router is transmitting signals
properly; proceed to Confirming that TCP Acceleration is operational on page 45.
If any other TxCode appears, the router is not transmitting signals properly. Click
the TxCode for explanation of the problem and/or troubleshooting information.
Note: The TxCode shown is an example.
Confirming that TCP Acceleration is operational
TCP Acceleration is a proprietary Hughes protocol that optimizes performance for
TCP/IP-based applications, including faster downloads over satellite.
Figure 28: Reception Info page
Figure 29: Transmission Info page
link.
Transmission Info
Chapter 4 • Troubleshooting
1039457-0001 Revision A
45