Connecting The Hx200 Satellite Router To A Computer; Unable To Access Enterprise Resources - Hughes HX200 Installation Manual

Connecting the HX200
satellite router to a
computer
Unable to access enterprise
Chapter 4 • Completing the installation
38
1038054-0001 Revision A.04 - Inspection Draft
Using an Ethernet cable, connect the HX200 satellite router to the
remote user's computer as shown in Figure 23. You can also
connect an Ethernet hub, router, or switch to the HX200 to
support additional computers that may be connected to remote
user's local area network (LAN).
If, after connecting the HX200 satellite router to the computer,
resources on the enterprise network cannot be accessed, perform
resources
the following procedures:
1. Configure the installer laptop so that its network properties
match those of the remote user's PC. Refer to Appendix D for
detailed instructions for setting network properties.
2. Connect the installer laptop to the HX200 with an Ethernet
cable and open a web browser.
3. Attempt to access the HX200 System Control Center as
explained in Chapter 5 – The System Control Center or by
TO BE REPLACED
Figure 23: Final configuration