Entering Satellite Parameters Manually - Hughes HX200 Installation Manual

Chapter 3 • Commissioning the HX200 satellite router
30
1038054-0001 Revision A.04 - Inspection Draft
TO BE REPLACED
Figure 16: Entering satellite parameters manually
d. If an outdoor pointing interface (OPI) is used to point the
antenna, check the
e. Click Next.
4. Verify that the information on the Verification of Satellite
Parameters screen shown in Figure 17 is correct. If using an
OPI, check the
Note: You are only required to verify satellite parameters if
you selected the satellite and transponder as shown in
Figure 15. If you entered the satellite parameters manually,
the Verification of Satellite Parameters screen does not
appear.
Enable OPI Display
check box.
Enable OPI Display
check box.