Spreading Disabled; Spreading Enabled; Sample Of Allowed Inroute Symbol Rates With Spreading Disabled - Hughes HX200 Installation Manual

Figure 6: Sample of allowed inroute symbol rates with spreading disabled
Chapter 3 • Commissioning the HX200 satellite router
18
1038054-0001 Revision A.04 - Inspection Draft
changes. After a successful reboot, follow the steps described in
the remainder of this section to insure that the satellite router is
functioning within the established parameters.

Spreading disabled

1. From the satellite router's Advanced web page, click the
Transmitter
allowed inroute rates based on the transmit radio wattage
selection.
2. Verify that the radio wattage displayed here matches the
selection made on the Manual Commissioning page.
3. Under
Local Parameters
4. In the table, verify that all the inroute rates below the
minimum allowed value (specified under Local Parameters)
are disabled.
TO BE REPLACED

Spreading enabled

1. From the satellite router's Advanced web page, click the
Transmitter
link. This link displays the
→ Allowed Inroutes
verify that spreading is disabled.
link. This link displays the
Allowed Inroutes
→