Powering Up And Observing The Leds - Hughes HX200 Installation Manual

Powering up and
observing the LEDs
3. Connect the power cable.
Note: A surge protector is recommended.
Note: Do not connect any devices to the HX200 at this time.
Connect serial and Ethernet devices to the device only after it is
fully installed and commissioned.
CAUTION
Do not connect or disconnect the Tx or Rx IFL cable while
the IDU is powered on; this action may result in damage to
the BUC, LNB and/or IDU.
Turn the AC power switch located on the satellite router to ON.
When power is applied to the HX200, or after it resets, the
satellite router light-emitting diodes (LEDs) will light in the
following sequence.
1. All LEDs illuminate for 1/2 second.
2. The Power LED lights up steadily, indicating that the HX200
is powered up.
3. The LAN LED lights up within 30 seconds, indicating that
LAN connectivity is detected.
4. The Power LED blinks, indicating that the unit is not
commissioned and therefore is running
rather than
main.bin.
Note: In countries outside North America, the HX200 may be
plugged directly into a 240V outlet with a replacement power
cord. Different countries may have different standards and
requirements.
CAUTION
• To remove power from a satellite router, turn the power
switch to the OFF position.
• Satellite routers must be used with 100/240-volt AC
Input.
• If the satellite router is installed in any country outside
the United States and Canada, always observe the
power standards and requirements of that country.
Chapter 2 • Assembling and connecting HX200 hardware
1038054-0001 Revision A.04 - Inspection Draft
fallback.bin
13