Entering Location Manually - Hughes HX200 Installation Manual

Chapter 3 • Commissioning the HX200 satellite router
28
1038054-0001 Revision A.04 - Inspection Draft
TO BE REPLACED
Figure 14: Entering location manually
3. At the Satellite Parameters screen shown in Figure 15, click
the
satellite and transponder listed either on the work order or in
the installation specification, and click Next.
The satellite parameters should have been provided to you in
either a technical update e-mail or an installation
specification. If the satellite and transponder for the
installation are not listed in the drop-down menu, and you
were not provided with an
steps a through d below to enter the satellite parameters
manually.
a. Select the
on the Satellite Parameters screen.
Satellite Transponders
Enter satellite parameters manually
drop-down menu, select the
file, you must complete
sbc.cfg
check box