Accessing The System Control Center; Confirming That The Satellite Router Is Commissioned; Checking The Receive Signal; Weather And Signal Strength - Hughes HX200 Installation Manual

Accessing the System
Confirming that the satellite
router is commissioned

Checking the receive signal

Weather and signal strength Heavy rain or snow can interfere with signal strength. In such
Checking the transmit
Chapter 6 • Troubleshooting
80
1038054-0001 Revision A.04 - Inspection Draft
Access the HX200 System Control Center by opening a web
browser on a computer connected to the HX200 and using one of
Control Center
the following methods:
Follow these steps to confirm that the HX200 satellite router has
been properly commissioned:
1. Navigate to the System Control Center System Information
2. In the area labeled HX200 Info, check the Site ID field. If the
Follow these steps to confirm that the HX200 is receiving
satellite signals properly:
1. Navigate to the System Control Center Reception
2. In the
conditions, the satellite router may stop receiving satellite signals,
and the Receive LED may go out as a result. Similar conditions at
the HX system gateway can interfere with signals for brief
periods of time as well. In addition, the buildup of moisture,
snow, or ice on the antenna can interfere with the signal. Signal
strength should be restored as the rain or snow subsides.
Follow these steps to confirm that the HX200 is properly
transmitting signals to the satellite:
signal
1. Navigate to the System Control Center Transmission
2. In the
• Type
192.168.0.1
alternate IP address was assigned to the HX200 at the system
gateway, use that IP address instead.
• Press E
.
NTER
page.
numeric site ID appears, the HX200 has been commissioned
properly. Proceed to Checking the receive signal.
If the phrase
Not Commissioned
occurred during the commissioning process. Recommission
the satellite router.
Information page.
Receive Status
If the Rx Code reads
, the satellite router is receiving signals properly. Proceed
5)
to Checking the transmit signal. If any other Rx Code
appears, the satellite router is not receiving signals properly.
Click on the Rx Code and follow the troubleshooting
procedures that appear on the screen.
Information page.
Transmit Status
in the browser address field, or if an
appears, an error
field, check the Rx Code.
Receiver operational (RxCode
field, check the Tx Code.