Uploading The Sbc Configuration File To The Hx200 - Hughes HX200 Installation Manual

Uploading the SBC
configuration file to the
HX200
Also, make sure that neither an Ethernet router nor a switch is
currently connected to the satellite router, then try the ping test
again. If the test is still unsuccessful, contact Technical Support
for assistance.
The SBC configuration file (
information that SBC and the auto-commissioning server (ACS)
must use during the commissioning process. Once you have
obtained the
sbc.cfg
sure to note the location in which the file is saved; then complete
the steps below.
Note: If you do not have to upload an
satellite router, skip this section and go to Commissioning the
HX200 on page 27.
1. Open a browser on the installer laptop.
2. Type
http://192.168.0.1/fs/registration/
in the address bar and press E
setup.html
alternate IP address was assigned to the satellite router at the
HX system gateway, enter that IP address instead. The
Broadband Satellite Setup screen appears as shown in
Figure 12.
Chapter 3 • Commissioning the HX200 satellite router
1038054-0001 Revision A.04 - Inspection Draft
) contains satellite
sbc.cfg
file, save it on the installer laptop, making
sbc.cfg
file to the
. If an
NTER
25