Satellite Router Front Panel Led Operation - Hughes HX200 Installation Manual

LED Appearance
Transmit On
Blinking, mostly on
Blinking, mostly off
Off
Receive On
Blinking
Off
Table 9: Satellite router front panel LED operation
OK.
Transmitting data.
The satellite router is ranging (measuring the distance to the satellite to
calibrate transmit timing and transmit power).
Condition preventing transmission.
If the HX200 is not operating normally and the receive LED is off, follow these
steps:
1. Check all cable connections and tighten any connections that seem loose.
(See the Caution statement that follows Figure 3 on page 11.)
2. If the LED still does not light up, power cycle the satellite router by turning it
off using the power switch on the rear panel, waiting 10 seconds, and then
turning it back on.
3. If the problem persists, contact Technical Support.
OK.
Receiving data.
Condition preventing acquisition of outroute (preventing receipt of data).
If the HX200 is not operating normally and the receive LED is off, follow these
steps:
1. Check all cable connections and tighten any connections that seem loose.
(See the Caution statement that follows Figure 3 on page 11.)
2. If the LED still does not light up, power cycle the satellite router by turning it
off using the power switch on the rear panel, waiting 10 seconds, and then
turning it back on.
3. If the problem persists, contact Technical Support.
Note: Often, if the Receive LED is off, the other LEDs may also be off.
Description
Chapter 6 • Troubleshooting
1038054-0001 Revision A.04 - Inspection Draft
75