Configuring A Windows Computer To Support Dhcp; Windows Xp - Hughes HX200 Installation Manual

Configuring a Windows computer to

Windows XP

This appendix explains how to configure a site computer to
support Dynamic Host Configuration Protocol (DHCP). All
HX200 satellite router come from the factory with DHCP
enabled. Therefore, the computer must have DHCP enabled and
set to obtain IP addresses automatically.
The following topics are discussed:
• Windows XP on page 87
• Windows 2000 on page 90
• Windows 98SE and Me on page 93
1. From the Windows desktop, select
. Double-click the
Panel
icon.
Note: If the Control Panel is in Category view, select
Network and Internet Connections, then select Network
Connections.
2. A list of network adapters appears as shown in Figure 46.
The
Local Area Connection
or High-Speed Internet heading. If it does not, the network is
not installed correctly.
Appendix A • Configuring a Windows computer to support DHCP
1038054-0001 Revision A.04 - Inspection Draft
Appendix A
support DHCP
Start→ Settings→ Control
Network and Dial-up Connections
icon must appear under the LAN
87