Accessing The Registration Server - Hughes HX200 Installation Manual

Chapter 3 • Commissioning the HX200 satellite router
34
1038054-0001 Revision A.04 - Inspection Draft
12. Select the
on the Registration Server Selection screen. You may also
manually enter the registration server address by following
these steps:
a. Select the
check box.
b. Enter the registration server's address in the
c. Select the
secure connection to the registration server.
13. Click Next.
The satellite connection is established.
14. Click Next when prompted to do so.
15. Click OK on the pop-up dialog shown in Figure 20 to access
the registration server.
Figure 20: Accessing the registration server
16. If the Security Alert pop-up dialog appears as shown in
Figure 21, click Yes to accept the security certificate.
Figure 21: Accepting the security certificate
17. Enter the site ID on the enterprise registration screen shown
in Figure 22 and click Continue.
server from the drop-down list
SiteID_Registration
Enter Registration Server address manually
Secure HTTP Mode
field.
HTTP://
check box to enable a