System Control Center Home Page - Hughes HX200 Installation Manual

Chapter 5 • The System Control Center
44
1038054-0001 Revision A.04 - Inspection Draft
Note: The HX200 LAN1 port has a default address of
192.168.0.1 and the LAN2 port has a default address of
192.168.1.1. These are the addresses that are typically used
to access the System Control Center from a computer
connected to either of the HX200 Ethernet ports. However,
it is possible to assign alternate addresses to these ports at
the HX system gateway. If alternate addresses have been
assigned, use those addresses instead of the addresses listed
in the procedure. If you do not know the correct IP
addresses, contact the HX system gateway administrator.
1. Open the web browser.
2. Type
192.168.0.1
alternate IP address was assigned to the satellite router at the
HX system gateway, use that IP address instead.
3. Press E
NTER
as shown in Figure 27.
Note: The computer used to browse to the System Control
Center must be on the same subnet as the satellite router.
TO BE RPLACED
Figure 27: System Control Center home page
, in the browser address field or, if an
. The System Control Center home page appears