Safety-Operating Conditions For Canada; Repairs In Canada; Safety, Emission, And Immunity Standards - Hughes HX200 Installation Manual

Safety-operating conditions
Repairs in Canada Repairs to certified equipment should be made by an authorized
Safety, emission, and
immunity standards
Appendix F • Conforming with standards and directives
118
1038054-0001 Revision A.04 - Inspection Draft
In addition to the warnings and safety guidelines listed in this
document, the following operating conditions apply to the
for Canada
HX200 and HX260 satellite routers used in Canada:
The Canadian Department of Communications label identifies
certified equipment. This certification means that the equipment
meets certain telecommunications network protective operational
and safety requirements. The Department does not guarantee that
the equipment will operate to the user's satisfaction.
Before installing the equipment, users should make sure they are
permitted connect to the facilities of the local
telecommunications company. The equipment must also be
installed using an acceptable method of connection. In some
cases, the company's inside wiring associated with a single line
individual service may be extended by means of a certified
connector assembly (telephone extension cord). The customer
should be aware that compliance with the above conditions may
not prevent degradation of service in some situations.
Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications
company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical
ground connections of the power utility, telephone lines, and
internal metallic water pipe system, if present, are connected
together. This precaution may be particularly important in rural
areas.
Do not attempt to make such connections, instead contact the
appropriate electrical inspection authority or electrician as
appropriate.
Table 14 identifies the system compliance with safety, emission,
and immunity standards. The HX200 and HX260 comply with
the European R&TTE (Radio and Telecommunications Terminal
Equipment) directive as well as the EMI standards of the US
(FCC) and Canada (CSA), as detailed in subsequent sections. The
installation and maintenance procedures in the installation and
configuration guides must be followed to ensure compliance with
these standards.
CAUTION