Conducting The Site Survey; Connecting The Receive And Transmit Cables; Connecting The Receive And Transmit Cables To The Satellite Router - Hughes HX200 Installation Manual

Conducting the site survey

Connecting the receive
and transmit cables
Figure 3: Connecting the receive and transmit cables to the satellite router
CAUTION
• Do not block any ventilation openings. Do not install near
heat sources, such as radiators, heat registers, ovens,
stoves, or other apparatus (including amplifiers) that
produce heat.
• To ensure ventilation and prevent overheating, leave six
inches of space between the front and rear panels of the
satellite router assembly and any adjacent equipment or
structure. Ventilation is necessary to avoid overheating.
Survey the installation site to confirm that it fulfills all the
requirements for using the HX system service. This includes
confirming that there is an unobstructed line-of-sight to the
appropriate satellite.
Additionally, review the installation specification or work order
for site-specific instructions.
Connect the receive cable to the Satellite In connector on the
satellite router as shown in Figure 3.
The HX200 offers two radio transmit options: saturated or linear.
The operator may select only one radio transmit option at any
time. There are potential ramifications to both software and
hardware if a cable is secured to the incorrect output connector or
if cables are connected to both outputs. For instance, a Linear
Radio transmit cable should not be connected to the Sat Out
Saturated connector on the back of the HX200 satellite router.
Chapter 2 • Assembling and connecting HX200 hardware
1038054-0001 Revision A.04 - Inspection Draft
11