Sample Of Allowed Inroute Symbol Rates With Spreading Enabled - Hughes HX200 Installation Manual

TO BE REPLACED
Figure 7: Sample of allowed inroute symbol rates with spreading enabled
allowed inroute rates based on the transmit radio wattage
selection.
2. Verify that the radio wattage displayed here matches the
selection made on the Manual Commissioning page.
3. Under
Local Parameters
4. Verify that all the inroute rates 256K and above are displayed
in the table. (The actual group selection conforming to the
FCC power control regulations is performed automatically by
the satellite router.)
Figure 7 shows a scenario where during manual commissioning,
an 8W radio was selected and spreading was enabled. As shown
under
Local Parameters
inroute symbol rate is 256KSps (pre-spreading) and 1024KSps
(post-spreading) since 256K x 4 = 1024KSps is a valid
configuration. Consequently, as shown in the figure, all symbol
rates including and above 256Ksps are marked as allowed.
Chapter 3 • Commissioning the HX200 satellite router
1038054-0001 Revision A.04 - Inspection Draft
verify that spreading is enabled.
on this page, the minimum allowed
19