Computer And Networking Requirements; Computer Requirements - Hughes HX90 Installation Manual

Computer and networking requirements

Computer requirements

Table 2: Power supply specifications for the HX90 satellite router
Power supply type
AC/DC (64 W)
AC/DC (80 W)
DC/DC (65 W)
All listed power supplies may be used with a 1 W or 2 W Ka-band or
Ku-band radio. All have a detachable power cord.
This section lists the requirements for the computer or other device, network, and
browser to be used with the satellite router.
The HX90 satellite router can be used with any device that supports IP and has a
10/100 BaseT Ethernet LAN port. Typically, the router is connected to a customer's
computer. However, the HX90 is self-hosted; it does not require a computer for any
of its functions.
Requirements for the computer to be used with the satellite router are the same for
the laptop computer you use to install the router and the customer's computer that
will be connected to the router. In either case, the computer should meet the
minimum requirements specified by the computer operating system manufacturer
and the following networking and browser requirements.
Make sure the installer laptop is configured to support DHCP.
Note: The satellite router can be used with a Mac computer that meets these
requirements, but Mac computers are not supported as a tool for installing
the satellite router.
Electrical requirements
Input line voltage:
90 to 264 VAC, 2 A maximum
Input line frequency:
50 to 60 Hz AC
Rated power consumption: 64 W
Input line voltage:
90 to 264 VAC, 2 A maximum
Input line frequency:
50 to 60 Hz AC
Rated power consumption: 80 W
Input line voltage:
12 to 24 VDC, 10 A maximum
Rated power consumption: 65 W
Chapter 2 • Preparing for installation
1039456-0001 Revision A
17