Gain Adjustment Mode - Mitsubishi Electric MR-J4-10B(-RJ) Instruction Manual

6. NORMAL GAIN ADJUSTMENT
3) [Pr. PB08 Position loop gain]
This parameter determines the response level to a disturbance to the position control loop.
Increasing the value increases the response level to the disturbance, but a too high value will
increase vibration of the mechanical system.
Position loop gain guideline ≤
4) [Pr. PB07 Model loop gain]
This parameter determines the response level to a position command. Increasing the value
improves trackability to a position command, but a too high value will make overshoot liable to
occur at settling.
Model loop gain guideline ≤

6.5 2 gain adjustment mode

The 2 gain adjustment mode is used to match the position loop gains of the axes when performing the
interpolation operation of servo motors of two or more axes for an X-Y table or the like. In this mode,
manually set the model loop gain that determines command trackability. Other parameters for gain
adjustment are set automatically.
(1) 2 gain adjustment mode 1 (interpolation mode)
The 2 gain adjustment mode 1 manually set the model loop gain that determines command trackability.
The mode constantly estimates the load to motor inertia ratio, and automatically set other parameters for
gain adjustment to optimum gains using auto tuning response.
The following parameters are used for 2 gain adjustment mode 1.
(a) Automatically adjusted parameter
The following parameters are automatically adjusted by auto tuning.
(b) Manually adjusted parameter
The following parameters are adjustable manually.
Speed loop gain
(1 + Load to motor inertia ratio)
Speed loop gain
(1 + Load to motor inertia ratio)
Parameter Symbol
PB06 GD2 Load to motor inertia ratio/load to motor mass ratio
PB08 PG2 Position loop gain
PB09 VG2 Speed loop gain
PB10 VIC Speed integral compensation
Parameter Symbol
PA09 RSP Auto tuning response
PB07 PG1 Model loop gain
6 - 25
1 1
to
×
4 8
1 1
to
×
4 8
Name
Name