11. OPTIONS AND PERIPHERAL EQUIPMENT
11.9 Selection example of wires
The following diagram shows the wires used for wiring. Use the wires given in this section or equivalent.
2) Control circuit power supply lead
5) Power regeneration converter lead
POINT
Refer to section 11.1.3 for SSCNET III cable.
To comply with the IEC/EN/UL/CSA standard, use the wires shown in app. 4 for
wiring. To comply with other standards, use a wire that is complied with each
standard.
For the selection example when the MR-J4-_B-RJ servo amplifier is used with
the DC power supply input, refer to app. 15.3.
Selection conditions of wire size are as follows.
Construction condition: Single wire set in midair
Wire length: 30 m or less
1) Main circuit power supply lead
Power supply
Power regeneration
converter
Regenerative option
3) Regenerative option lead
Servo amplifier
L1
L2
L3
L11
L21
N-
C
P+
11 - 69
U
V
W
4) Servo motor power supply lead
M